Minolta Di350 - PRECAUTIONS FOR INSTALLATION; Power Source Requirements; Grounding Procedures

FrameMaker Ver.5.5E(PC) Di350 GENERAL, MECHANICAL/ELECTRICAL
98.12.18
G-10
1171SBG0300A
Installation Site
To ensure safety and utmost performance of the copier, the copier should NOT be used in a
place:
•
Where it will be subjected to extremely high or low temperature or humidity.
•
Which is exposed to direct sunlight.
•
Which is in the direct air stream of an air conditioner, heater or ventilator.
•
Which puts the operator in the direct stream of exhaust from the copier.
•
Which has poor ventilation.
•
Where ammonia gas might be generated.
•
Which does not have a stable, level floor.
•
Where it will be subjected to sudden fluctuations in either temperature or humidity. If a
cold room is quickly heated, condensation forms inside the copier, resulting in blank
spots in the copy.
•
Which is near any kind of heating device.
•
Where it may be splashed with water.
•
Which is dirty or where it will receive undue vibration.
•
Which is near volatile flammables or curtains.
Power Source
Use an outlet with a capacity of 120V/10A, or 220V to 240V/5A or more.
•
If any other electrical equipment is sourced from the same power outlet, make sure that
the capacity of the outlet is not exceeded.
•
Use a power source with little voltage fluctuation.
•
Never connect by means of a multiple socket any other appliances or machines to the
outlet being used for the copier.
•
Make the following checks at frequent intervals:
✽
Is the power plug abnormally hot?
✽
Are there any cracks or scrapes in the cord?
✽
Has the power plug been inserted fully into the outlet?
✽
Does something, including the copier itself, ride on the power cord?
•
Ensure that the copier does not ride on the power cord or communications cable of other
electrical equipment, and that it does not become wedged into or underneath the mecha-
nism.
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always ground the
copier.
•
Connect the ground wire to:
✽
The ground terminal of the outlet.
✽
A grounding contact which complies with the local electrical standards.
•
Never connect the ground wire to a gas pipe, the ground wire for a telephone, or a water
pipe.
3 PRECAUTIONS FOR INSTALLATION