Minolta Di350 - Sub Hopper Toner Empty Detecting Mechanism

FrameMaker Ver.5.5E(PC) Di350 GENERAL, MECHANICAL/ELECTRICAL
98.12.18
M-30
1171SBM1305A
•
A toner-empty condition in the Sub Hopper is detected by the Magnet Lever that moves
up and down as the Sub Hopper Toner Agitating Lever turns and actuates and deactu-
ates the Sub Hopper Toner Empty Switch.
•
While the amount of toner in the Sub Hopper is more than the predetermined amount,
the Magnet Lever rests on the toner, keeping the Sub Hopper Toner Empty Switch deac-
tuated even when the Sub Hopper Toner Agitating Lever turns. As toner is consumed,
the Magnet Lever lowers to eventually actuate the Sub Hopper Toner Empty Switch, at
which timing the copier detects a toner-empty condition in the Sub Hopper.
13-5. Sub Hopper Toner Empty Detecting Mechanism
Electrical Component Control Signal ON OFF
S4 PJ11A-7B L H
1171M021AA
Sub Hopper Toner Empty Switch (S4)
Magnet Lever
Sub Hopper Toner Agitating Lever
Magnet