FrameMaker Ver.5.5E(PC) Di350 TROUBLESHOOTING
98.12.09
T-15
<Copier Take-Up Misfeed Troubleshooting Procedure>
Symptom Step Check Item Result Action
Paper is not taken
up at all.
1
Does the paper being used
meet the product specifica-
tions?
NO
Instruct the user to use the
paper that meets product
specifications.
2
Is the paper curled, wavy, or
damp?
YES
Change the paper. Instruct the
user on the storage of paper.
3
Are the Edge Guide and Trail-
ing Edge Stop (of the drawer)
positioned to the exact size of
the paper used?
NO
Slide the guides to the exact
size of the paper.
4 Is the Paper Take-Up Roll
deformed, worn, or dirty
with paper dust?
YES
Clean or change the Paper
Take-Up Rol l.
5
If the Paper Lifting Plate dirty
or deformed?
YES
Clean or change the Paper
Lifting Plate.
6
Has the misfeed been
detected while the Multi Pur-
pose Cassette was being
used?
YES
Check steps 7 and 8.
NO
Check steps 9 and onward.
7
Is the Paper Separator Pad
deformed, worn, or dirty with
paper dust?
YES
Clean or change the Paper
Separator Pad.
8
Check SL1 for operation.
Does the voltage across
CN19-1 on the PWB-A side
and GND change from DC24V
to DC0V when the Start key is
pressed?
YES
Check various parts for possi-
ble overload and, if they are
okay, change SL1.
NO
Change PWB-A.
9
Is the Paper Separator Finger
dirty or deformed?
YES
Clean or change the Paper
Separator Finger.
10
Check CL2 for operation.
Does the voltage across CN9-
1 on the PWB-A side and GND
change from DC24V to DC0V
when the Start key is pressed?
NO
Change PWB-A.
11
Check SL1 for operation.
Does the voltage across PJ3A-
1A on PWB-A (Cassette Main
Board) and GND change from
LOW to HIGH when the Start
key is pressed?
YES
Check various parts for possi-
ble overload and, if they are
okay, change SL1 or CL2.
NO
Change PWB-A (Cassette
Main Board) or PWB-A.
•
Paper is at a
stop before the
vertical trans-
port section.
•
Paper is at a
stop near the
Synchronizing
Rollers.
1
Is the Vertical Transport Roller
deformed, worn, or dirty with
paper dust?
YES
Clean or change the Vertical
Transport Roller.
2
If the Vertical Transport Guide
Plate dirty or deformed?
YES
Clean or change the Vertical
Transport Guide Plate.
3
Is PC2 fully operational?
Check the input data using I/O
Check.
YES
Check various parts for possi-
ble overload and, if they are
okay, change PWB-A.
NO
Check the PC2 actuator for
operation and, if it is intact,
change PC2.
To Next Page
Loading...
