Minolta DiMAGE F100 - Changing the Memory Card (Data-Transfer Mode)

116
DATA -TRANSFER MODE
Changing the memory card (Data-transfer mode)
Care should be taken when changing memory cards while the camera is attached to the computer.
Data could be lost or damaged if the camera is not properly disconnected.
Windows 98 and 98SE
1. Turn off the camera.
2. Change the memory card.
3. Turn on the camera to remake the USB connection.
Windows ME, 2000 professional, and XP
Macintosh
Always confirm the access lamp is not red
before removing the memory card.
1. Stop the USB connection using the unplug-or-eject-hardware routine (p. 114).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
1. Stop the USB connection by dragging the drive icon into the trash (p. 115).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.