18
GETTING UP AND RUNNING
Changing the memory card
An SD Memory Card or MultiMediaCard must be inserted for the camera to operate. If a card has not
been inserted, a no-card warning will automatically be displayed on the monitor and three dashes (–
– –) will be displayed on the data-panel frame counter. For memory card care and storage, see page
122.
Open the card-slot door (1) from the fingernail notch at the bottom of the camera.
Insert the memory card all the way into the card slot and release (2). The card should catch in the
slot.
• Insert the card so the face is toward the front of the camera. Always push the card in straight.
Never force the card. If the card does not fit, check that it is orientated correctly.
Close the card-slot door (4). The door should click into place.
To eject a memory card, press the card into the slot and release (3). The card can now be pulled out.
•Take care when removing the card as it becomes hot with use.
1
Always turn off the camera and confirm the power/access lamp is not red before
inserting or removing a memory card; the card may be damaged, and data lost.
234
To Next Page
Loading...
Need help?
General
