41
The continuous-advance drive mode allows a series of images to be captured while holding down the
shutter-release button. Continuous advance acts like a motor drive on a film camera. The number of
images that can be captured at one time and the rate of capture depend on the image-quality and
image-size setting. The maximum rate of capture is 1.2 fps with the shutter FX on (p. 101), or 1.5 fps
with it off.The continuous-advance mode is set on the auto-recording mode menu and in the basic
section of the multi-function recording mode menu (p. 56).
When the shutter-release button is pressed and held, the camera will begin recording
images until the maximum number has been taken or the shutter button is released. If
super-fine image quality (p. 46) is selected, only one image will be captured. The built-
in flash can be used, but the rate of capture is reduced because the flash must
recharge between frames.
Compose the picture as described in the basic recording opera-
tion section (p. 26). Press the shutter-release button partway
down to lock onto the subject and set the exposure for the series.
Press and hold the shutter-release button all the way down (1) to
begin taking pictures.
The following chart lists the maximum number of images that can
be captured with different image-quality and image-size combinations.
Economy
Standard
Fine
2272 X 1704
Image
Quality
Image
Size
1600 X 1200 1280 X 960 640 X 480
4
8
16
8
16
32
13
26
49
49
91
156
1
Continuous advance
To Next Page
Loading...
Need help?
General
