Minolta DYNAX 7 - NAVIGATION DISPLAY; DISPLAY SELECTION

To Next Page

To Previous Page

(2181) 19

REPAIR GUIDE

■■

■

Fig. 5Fig. 5

Fig. 5

■■

■

Fig. 6Fig. 6

Fig. 6

■■

■

Fig. 7Fig. 7

Fig. 7

51075107

5107

51085108

5108

05130513

0513

05130513

0513

MIRROR DRIVE LEVERMIRROR DRIVE LEVER

MIRROR DRIVE LEVER

MAIN MIRROR DRIVE LEVER ASSYMAIN MIRROR DRIVE LEVER ASSY

MAIN MIRROR DRIVE LEVER ASSY

MAIN MIRROR HOLDER ASSYMAIN MIRROR HOLDER ASSY

MAIN MIRROR HOLDER ASSY

MAIN MIRROR HOLDER ASSYMAIN MIRROR HOLDER ASSY

MAIN MIRROR HOLDER ASSY

MarkMark

Mark

Main Page

Table of Contents1
Discharge2
Precautions2
To Activate Without Exterior Parts3
To Inhibit Flash Charge3
Disassembly of the Exterior Parts4
- Wires Arrangement5
Disassembly of the TEBURE ASSY, SHUTTER ASSY7
Disassembly of the MIRROR BOX ASSY, BATTERY HOLDER10
Disassembly of the IMAGE BOARD ASSY, MAIN BOARD ASSY11
Disassembly-1 of the MIRROR BOX ASSY13
Disassembly-2 of the MIRROR BOX ASSY15
Disassembly-3 of the MIRROR BOX ASSY17
Disassembly of the TOP COVER ASSY20
Disassembly of the BACK COVER ASSY24
Disassembly of the CCD ASSY, DC JACK HOLDER26
Disassembly of the CARD COVER HOLDER, SIDE COVER, FRONT COVER ASSY27
- How to Replace "SHUTTER ASSY28
- Required Adjustment, Setting and Confirmation Items after Repairing (Exchanging Parts)30
- Related Adjustment and Required Setting Items32
- Using HIT System33
- Adjustment/Check Items Available with 2181 ROM Pack34
- Viewfinder Back Adjustment35
- Manual Set SS & X-Sync. Time-Lag Check36
- Manual Set SS Adjustment37
- SPC Position Adjustment38
- Aperture Preset Check/Adjustment39
- PI-PR Adjustment40
Preparation before AF Adjustment42
①AF Area Adjustment43
② Pitch Yaw Adjustment44
③ EZ Check45
④EZ Adjustment46
Assist MODE47
LCD Displays Check47
Preparing the 2181 Adjustment Program48
Starting up the 2181 Adjustment Program (in the Adjustment Mode)49
Back up Flash ROM Data of Master Body50
Adjustment of CCD Vsub Voltage51
Setting of Master Body and Chart for the Adjustment of CCD Position52
Adjustment of CCD Position and Perspective53
Adjustment of the Frequency for Camera Shaking (ACT DRV FREQ)55
Adjustment of the Gyro for Camera Shaking (GYRO)55
Adjustment of the Servo for Camera Shaking (SERVO)55
Adjustment of the AE (AE)56
Sensitivity Adjustment (GAIN)57
Adjustment of the Defective Pixel (DEFECT PIXEL)58
Adjustment of White Balance (WB)59
Adjustment of the Camera Shaking Compensation (SHAKE GAIN)60
Distination Seting(DISTINATION)61
Light Source-A Maintenance62
Error Code on Adjustment Program63
Measuring Instrument65
Subsidiary Materials66

Minolta DYNAX 7 - NAVIGATION DISPLAY; DISPLAY SELECTION

Table of Contents

Other manuals for Minolta DYNAX 7

Related product manuals