MIOX RIO Series Operators Manual
P/N: 102-00076-G Page 13
Recommended Tools for Installation: RIO Series OSG
Mechanical Tools
• Forklift, pallet jack, or crane - unload and place equipment
• Hammer - remove crating
• Pry bar - remove crating
• 2-¾” end wrenches or equivalent - connect cell
• Channel locks or equivalent slip joint pliers - tighten plumbing connections
• Phillips screw driver - make main electrical connections
• Small flat screwdriver - connect control relay wiring
• Wire strippers
• Allen wrench set
• Tape measure
Plumbing Tools
• PVC pipe cutter or saw
• PVC pipe reamer - remove burrs from cut pipe
• Glue - use correct type for pipe material
• Primer/cleaner - use correct type for pipe material
• Te f lo n Ta pe
• Strap wrench
• 12” pipe wrench
Untrained Persons should not attempt to install of operate MIOX equipment.
To Next Page
Loading...
