MIOX RIO Series Operators Manual
P/N: 102-00076-G Page 18
Control System/Rear Panel Connections
The RIO Series OSG features an Allen Bradley Micrologix 1400 PLC to maintain consistent cell
control. The operator interface is an Allen Bradley Panelview Plus 600 Touch screen display.
Connection to site SCADA systems is done directly from OSG controls using the RJ45 cable.
As an optional adder, a Red Lion CSMSTRSX Modular Controller can be used as a protocol
converter which can be configured to match plant communications. The interface can be
configured to support e-mail and SMS notification if the system shuts down for a fault that
requires operator attention.
In addition to providing internal control of the OSG, the RIO Series control system provides
connectivity to various external inputs and outputs (Figure 8).
A Modbus/Ethernet IP is built in PLC as a standard. For other communication options
available, contact MIOX.
Figure 8 Rear Panel Connections
To Next Page
Loading...
