TX3 Telephone Access System Installation and Operation Manual 3
Contents
1 Introduction 7
1.1 TX3 Systems 8
1.2 Features 10
1.3 Lobby Control Unit Enclosures 11
1.4 Lobby Control Unit Accessories 15
1.5 Mounting requirements from the 2010 ADA Standards for Accessible
Design 16
1.6 About This Manual 17
1.7 Warranty and Special Notices 17
1.8 Contact Us 17
2 Enclosure Installation 18
2.1 Grounding the Telephone Access System 18
2.2 Installing the Enclosures and Lobby Control Unit 18
2.3 Installing the Heater 27
3 TX3 System 28
3.1 TX3 System 28
3.2 Single Lobby Control Unit 29
3.3 Dual Lobby Control Units 32
3.4 Three Lobby Control Unit Configuration 33
3.5 Multiple Lobby Control Units 34
3.6 Networking TX3 Panels 34
3.7 Lobby Control Unit Wiring 37
4 Lobby Control Unit Setup 38
4.1 Controller Board 39
4.2 Controller Board Connectors - Bottom 41
4.3 Controller Board Connectors - Top 46
4.4 Modem Module 49
4.5 IP Module 50
4.6 RS-485 Add-on Module 50
4.7 Wiegand Output Module 52
4.8 Guard Phone Module 52
4.9 Guard Phone 53
4.10 Controller ID Setup 54
4.11 Configuration Using a PC 56
4.12 Updating Firmware 57
4.13 Beginning Configuration 58
5 NSL Relay Cabinet Installation and Wiring 60
5.1 NSL Relay Cabinet Mechanical Installation 61
5.2 NSL Relay Control Unit and Expanders 63
To Next Page
Loading...
