91
Software Installation
The MCD Software Installer Tool
Install the MCD Software Installer Tool
You can install the MCD Software Installer Tool on the
Installation/Maintenance PC, or on its own PC (see page 13 for PC
requirements).
To install the Software Installer:
1. Download the MCDSoftwareInstallerSetup_<version>.exe file from
MOL (MCD 5.0 or later) or insert the MCD software CD-ROM disk (disk
1 for R8.0 or earlier; disk 2 for R9.0 to MCD 4.x) into the Installer PC’s
CD drive.
2. For CD-based software only: Open the Tools folder, then the Mitel
Communications Director Software Installer folder.
3. Double-click the MCDSoftwareInstallerSetup_<version>.exe file.
Follow the prompts to install the Software Installer.
To launch the Software Installer:
• On the Start menu, point to Programs, and then click MCD Software
Installer.
Install System Software using the Software Installer
Tip: Assign a static IP address to the PC running the Software Installer.
Tip: Ports required by the Software Installer:
Prior to Release 7.0 - port 2002 and ports 49500-49549
Release 7.0 and later - port 443.
Tip: Refer to “Enable Licenses and Options” on page 29 to manage software
licenses online.
CAUTION: If you have a Universal NSU with a PRI database,
you must convert that database before you begin the install
(see “Converting a PRI Database on a Universal NSU” on
page 138).
To Next Page