Mitel 3300 - Program DHCP for VLAN (Prior to Rel 7.0)

399
Older Hardware and Software
Program DHCP for VLAN (prior to Rel 7.0):
Follow this procedure if using two DHCP servers: central server (external)
on a default VLAN and other (3300 DHCP Server) on the voice VLAN.
1. Set up the central DHCP Server with the following options:
- 130 MITEL IP PHONE, string value
- 132 VLAN ID
- 133 Priority, value of 1-6
- 134 Diffserv Code Point, integer value
2. Set up the 3300 ICP DHCP Server with the following options:
- 128 TFTP IP address format
- 129 RTC IP address format
- 130 MITEL IP PHONE, string value
- 132 VLAN ID
- 133 Priority, value of 1-6
- 134 Diffserv Code Point, integer value
3. Program the DHCP server on the 3300 ICP (see "Program the
Controller DHCP Server (MXe, CX/CXi, CX II/CXi II)" on page 76).
Windows 2000 FTP Server
Figure 163, Figure 164 and Figure 165 below show examples of the
settings needed on a Windows 2000 FTP server.
To program these FTP settings
1. Open the Computer Management control panel
(Start/Settings/Control Panels/Administrative Tools/Computer
Management).
2. In Services and Applications, click on Internet Information.
3. Program the settings as shown below (use the IP Address drop-down
menu to select the PC’s IP address).