Mitsubishi Electric MELSEC iQ-R-R6SFM - Device Test with Execution Conditions

10 TEST FUNCTION
10.2 Device test with execution conditions
157
10
10.2 Device test with execution conditions
Using the engineering tool, device/label values can be set for each execution of specified steps of programs.
This function enables to debug a specific ladder block without modifying the program even when the program is configured as
shown in the example below.
Before using the device test with execution conditions, check the version of the CPU module and the
engineering tool used. (Page 1008 Added and Enhanced Functions)
(1) The device is operated in accordance with the registered settings. (M0 of the step number 10 is on.)
RnCPU
RnENCPU
RnPSFCPU RnPSFCPU RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety) (Standard) (Safety)
(Redundant) (Process)
(1)
• Program : MAIN
• Step number : 10
• Device : M0
• State : ON
Registration
Registration
Engineering tool