APPX
Appendix 13 How to Use CPU Module Logging Configuration Tool
961
A
Menu items and setting methods
This section describes the operation method and/or setting windows of CPU Module Logging Configuration Tool.
Menu structure
The following table describes the menu structure of CPU Module Logging Configuration Tool.
Menu item Description
Project New Create a new project.
Open Open a stored project file.
Save Overwrite an edited project to the file and saves it.
Save As Save an edited project with a new file name.
Read Logging Setting from Memory Card (SD) Read the data logging setting written in the SD memory card attached to the
personal computer.
Write Logging Setting into Memory Card (SD) Write the settings being edited in a format with which the CPU module can
operate. Once the settings is directly written into an SD memory card attached to
the personal computer and then the SD memory card is mounted onto the CPU
module, the data logging starts.
Recent Files Open a recently used file.
Read GX Works3 Project Import a project of the engineering tool which is the read source for the label.
Exit Exit CPU Module Logging Configuration Tool.
Edit Delete Data Logging Setting Remove the data logging setting selected in the Edit item tree.
Copy and Add Data Logging Setting Copy and add the data logging setting selected in the Edit item tree.
Batch Data Insertion Configure the multiple setting items at once.
Cut Setting Item Cut the setting with a table format.
Copy Setting Item Copy the setting with a table format.
Paste Setting Item Paste the setting with a table format.
Paste device/label copied in other application software Paste a device/label which is copied in another application into a line selected.
(Existing data in the line are overwritten and erased.)
Insert Copied Setting Item Paste the copied setting with a table format.
Insert device/label copied in other application software Paste a device/label which is copied in another application into a line selected
and shift down existing data in the selected line and below.
Insert Cut Setting Item Paste the cut setting with a table format.
Delete Setting Item Remove the setting with a table format.
Move Setting Item Upward Move up a setting item.
Move Setting Item Downward Move down a setting item.
Device Batch Replacement Replace devices for all the settings.
View Switch Display Language Change the display language for menus and so on.
Online Transfer Setup Configure the communication setting used for connection to the CPU module.
Read Logging Setting Read the setting from the CPU module.
Write Logging Setting Write the setting to the CPU module.
Delete Logging Setting Remove the setting data from the CPU module.
Logging Status and Operation Check the data logging status.
Logging File Operation Connect to the CPU module and read or remove the files in the attached SD
memory card or data memory.
Data Logging File Transfer Status The transfer status of the data logging file is displayed.
Tool Start GX LogViewer Launch GX LogViewer.
Help Open Manual e-Manual Viewer opens and its manual is displayed.
Connection to MITSUBISHI ELECTRIC FA Global
Website
The Mitsubishi Electric Corporation FA website is displayed.
About Configuration tool The product information is displayed.
To Next Page
Loading...
