176
1 FUNCTIONS
1.13 Security Function
Setting procedure
Set the remote password as follows.
[Navigation window] [Parameter] [Remote Password]
1. Register the remote password on the "Register
Password" window.
[Password] button
2. Select the module for which the remote password is to
be applied, and set the start I/O number. Select the
following items when using the RnENCPU.
• CPU part: "CPU Module (Built-in Ethernet Function)"
• Network part: "CC-Link IE Built-in Ethernet I/F Module"
3. Set the target connection on the "Remote Password
Detail Setting" window.
"Detail Setting" for the target module.
4. Write the remote password to the CPU module.
5. The remote password is enabled when the CPU
module is powered off and on or reset.
To Next Page
Loading...
