386
APPX
Appendix 6 Communications with Different Networks
When the networks consist of only MELSEC iQ-R series
Communication paths are automatically set for communication with the following networks of MELSEC iQ-R series.
• Ethernet
• CC-Link IE Controller Network
• CC-Link IE Field Network
■Setting procedure
Use the following procedure.
1. Set the network number, station number, and transient transmission group number in the "Own Node Settings" under
"Basic Settings". ( Page 243 Communications by Network No./Station No.)
2. Set the "Network Dynamic Routing" under "Application Settings" to "Enable".
• Communication paths are automatically set, but they can also be manually set. To set communication paths
manually, refer to the following. ( Page 386 When the networks consist of MELSEC iQ-R series and
other series)
• The communication path cannot be set automatically for Ethernet-equipped modules connected via a
router. Set the communication path manually. ( Page 386 When the networks consist of MELSEC iQ-R
series and other series)
When the networks consist of MELSEC iQ-R series and other series
Setting communication paths allows communication with the following networks configured with modules other than MELSEC
iQ-R series.
• Ethernet
• CC-Link IE Controller Network
• CC-Link IE Field Network
• MELSECNET/H
• MELSECNET/10
■Setting procedure
Use the following procedure.
1. Set the network number, station number, and transient transmission group number in the "Own Node Settings" under
"Basic Settings". ( Page 243 Communications by Network No./Station No.)
2. Set the send destination station information in "Network/Station No. <-> IP information setting" under "Application
Settings". ( Page 265 Network/Station No. <-> IP information setting)
3. Set communication paths in "Routing Setting" of "CPU Parameter".
( MELSEC iQ-R CPU Module User's Manual (Application))
To Next Page
Loading...
