126
8.8 Write Logging Setting
Data logging setting data can be written to the target memory of the CPU module.
Stop the target data logging before writing the data logging setting. Also, all of the data loggings must be stopped when
writing the common settings.
(1) Operating procedure
1. Display the "Online Operation (Write Logging Setting)" screen.
[Online] [Write Logging Setting]
2. From the "Target memory" list, select the memory where the data are to be written.
3. Select the target data in the "Target logging setting data" area.
4. Click the button.
● If some data currently exist in the CPU module before writing, the common settings and the settings with the same No.
will be overwritten. Data other than the above will be held in the CPU module. Because of this, the data to be written may
not match the data written.
● If a remote password entry screen appears, enter the configured password.
For the remote password, refer to the following.
MELSEC-L CPU Module User’s Manual (Function Explanation, Program Fundamentals)
To Next Page
Loading...
