39
CHAPTER 4 PREPARATION AND SETUP
4
CHAPTER 4 PREPARATION AND SETUP
The following flowchart shows the steps to be performed before data logging operation.
For installation of the CPU module, power supply module, and SD memory card, and the installation environment, refer to
the following.
MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
Connect the CPU module to the personal computer.
Insert an SD memory card into the slot of the CPU module.
Power on the CPU module.
Set the CPU module switch to RUN.
Install the configuration tool.
Start the configuration tool.
Configure data logging settings.
CPU module
Start
Select a communication route in
"Transfer Setup" of the configuration tool.
Write the settings to the CPU module.
Start data logging.
Personal computer
Completed
Page 42, Section 5.2.1
Page 48, Section 5.3
Page 94, Section 8.4
Page 116, Section 8.6
Page 126, Section 8.8
Page 128, Section 8.9
To Next Page
Loading...
