Mitsubishi Electric MELSEC-L Series - Starting the Configuration Tool

48
5.3 Starting the Configuration Tool
The configuration tool can be started by the following three methods.
• Start from the Start menu
• Start from the programming tool
• Start from the viewer tool (GX LogViewer)
(1) Start from the Start menu
After installing the configuration tool, follow the procedure below.
[Start] [All programs] [MELSOFT Application] [Logging function]
[LCPU Logging Configuration Tool]
(2) Start from the programming tool
After starting the programming tool, follow the procedure below.
[Tool] [LCPU Logging Configuration Tool Start]
(3) Start from the viewer tool (GX LogViewer)
Refer to the following.
GX LogViewer Version1 Operating Manual