75
CHAPTER 7 OTHER FUNCTIONS
7
7.2 Auto Logging by Inserting an SD Memory Card
7.2 Auto Logging by Inserting an SD Memory Card
Writing auto logging settings to an SD memory card and inserting it into a running CPU module will automatically start
logging. Both of continuous logging and trigger logging are executable. Individual setting is not available for each of
setting No.1 to No.10. ( Page 114, Section 8.5.1)
(1) Procedure to use
The following is the procedure to use the auto logging function.
● A new data logging cannot be started during auto logging operation.
● After completion of auto logging, replace the SD memory card where the auto logging settings are stored. Otherwise,
another auto logging cannot be started.
(2) When data logging registration by the auto logging function failed
When multiple data logging settings are registered by the auto logging function, if a part of them has failed to be
registered, all of data logging will not be executed.
Prepare the SD memory card where the auto logging setting is stored.
Start
Insert the SD memory card into the slot of the running CPU module.
Slide the SD memory card lock switch upward, stop the card access,
and then remove the SD memory card.
Upon completion of auto logging, the SD LED starts flashing.
End
Data logging automatically starts.
The SD LED turns on.
To Next Page
Loading...
