74
CHAPTER 7 OTHER FUNCTIONS
This chapter describes the functions other than the data logging function.
7.1 Data Logging Operation at Transition to RUN
After registration of a data logging setting, logging operation for the following transition to RUN can be specified.
Setting is available for each of setting No.1 to No.10. ( Page 111, Section 8.4.11)
(1) Relevant operations
The relevant operations are shown below.
• Power OFF → ON
• Reset → RUN
•STOP → RUN
(2) Selectable operations
Select an operation from the following.
• Auto Start
• Start by User Operation
(a) When "Auto Start" is selected
Data logging is automatically started after the operation listed above.
To start the data logging at the first time, the user must perform a specific operation.
(b) When "Start by User Operation" is selected
Data logging is temporarily stopped after the operation listed above. To restart the data logging, the user must
perform a specific operation.
When the auto logging function is enabled, even if "Start by User Operation" is set, the same operation as "Auto Start" is
performed.
To Next Page
Loading...
