Mitsubishi Electric MELSEC-L Series - Chapter 8 How to Use the Configuration Tool; Setting Flow Chart

79
CHAPTER 8 HOW TO USE THE CONFIGURATION TOOL
8
8.1 Setting Flow Chart
CHAPTER 8 HOW TO USE THE CONFIGURATION
TOOL
This chapter describes the setting procedure and operations for data logging.
8.1 Setting Flow Chart
Follow the flow chart below to configure the settings.
Start
End
Configure the data logging settings.
Configure the settings required for data logging.
( )
( )
( )
( )
( )
( )
Execute or stop the data logging.
Enable auto logging?
Configure the auto logging settings.
Is data logging stopped?
Write the settings.
Start the data logging.
Stop the data logging.
Read the data logging file from the
SD memory card.
Check the CSV file.
Yes
No
Stop the data logging.
Yes
No
Before writing common settings,
all the data logging must be stopped.
Page 94, Section 8.4
Page 114, Section 8.5.1
Page 126, Section 8.8
Page 126, Section 8.8
Page 128, Section 8.9
Page 130, Section 8.10