6 - 172
6 POSITIONING CONTROL
(c) Parameter setting
The automatic refresh setting example for position follow-up control is
shown below.
[Allocation example of devices allocated in the Motion dedicated device to the PLC CPU]
• CPU No. 1 (PLC CPU) (GX Works2/GX Developer)
<Screen: GX Works2>
Set the device transmitted to CPU No.2 (M3200 to M3295)
Set the device received from CPU No.2
(M2400 to M2495, D40 to D59)
• CPU No. 2 (Motion CPU) (MT Developer2)
Set the device received from CPU No.1 (M3200 to M3295)
Set the device transmitted to CPU No.1
(M2400 to M2495, D40 to D59)
Multiple CPU high speed refresh setting (MT Developer2 only)
To Next Page
Loading...
