Mitsubishi Electric NZ2EX2B-60AD4 - Page 160

158
(3) Initial settings
(a) Station parameter
For the parameters other than the above, use the initial value.
(b) Basic module parameter
For the parameters other than the above, use the initial value.
(c) Ext. module 1_Module parameter
For the parameters other than the above, set up the initial value.
Setting item Setting value
Conversion speed setting 2: 100μs
Cyclic data update watch time setting 5
Setting item Setting value
A/D conversion enable/disable setting CH4 A/D conversion enable/disable setting 1: Disable
Average processing setting
CH2 Averaging process setting 2: Count average
CH2 Time average/Count average/Moving average 50
CH3 Averaging process setting 3: Moving average
CH3 Time average/Count average/Moving average 10
Input signal error detection function
CH1 Input signal error detection setting 4: Disconnection detection
CH3 Input signal error detection setting 4: Disconnection detection
Alert output function
CH2 Alert output setting 0: Enable
CH2 Process alarm upper upper limit value 16000
CH2 Process alarm upper lower limit value 10000
CH2 Process alarm lower upper limit value 3000
CH2 Process alarm lower lower limit value 0
Digital clipping function
CH2 Digital clipping enable/disable setting 0: Enable
CH3 Digital clipping enable/disable setting 0: Enable
Scaling function
CH3 Scaling enable/disable setting 0: Enable
CH3 Scaling upper limit value 32000
CH3 Scaling lower limit value 0
Setting item Setting value
Ext. module 1_Average processing setting
Ext. module 1_CH2 Averaging process setting 2: Count average
Ext. module 1_CH2 Time average/Count average/Moving
average
50
Ext. module 1_CH3 Averaging process setting 3: Moving average
Ext. module 1_CH3 Time average/Count average/Moving
average
10
Ext. module 1_Input signal error detection function
Ext. module 1_CH1 Input signal error detection function
setting
4: Disconnection detection
Ext. module 1_Alert output function
Ext. module 1_CH2 Alert output setting 0: Enable
Ext. module 1_CH2 Process alarm upper upper limit value 16000
Ext. module 1_CH2 Process alarm upper lower limit value 10000
Ext. module 1_CH2 Process alarm lower upper limit value 3000
Ext. module 1_CH2 Process alarm lower lower limit value 0
Ext. module 1_Digital clipping function
Ext. module 1_CH1 Digital clipping enable/disable setting 0: Enable
Ext. module 1_CH2 Digital clipping enable/disable setting 0: Enable
Ext. module 1_Scaling function
Ext. module 1_CH1 Scaling enable/disable setting 0: Enable
Ext. module 1_CH1 Scaling upper limit value 32000
Ext. module 1_CH1 Scaling lower limit value 0