3 SPECIFICATIONS
3.2 Performance Specifications
19
3
NZ2MF2S2-16A AC input module
*1 Only one wire can be connected to a terminal of the terminal block for module power supply and FG or the terminal block for input.
Multiple wires cannot be connected to a terminal. Connecting two or more wires may cause a poor contact.
*2 It is recommended to use the bar solderless terminal for wiring.
Item NZ2MF2S2-16A
Station type Slave station
Number of input points 16 points
Rated input voltage/rated frequency 100 to 120VAC (+10%/-15%), 50/60Hz (3Hz)
Rated input current 8.2mA (100VAC, 60Hz), 6.8mA (100VAC, 50Hz)
Inrush current 200mA maximum within 1ms
Input voltage distortion ratio Within 5%
Max. number of simultaneous input points 100%
ON voltage/ON current 80VAC or more/5mA or more (50Hz, 60Hz)
OFF voltage/OFF current 30VAC or less/1.7mA or less (50Hz, 60Hz)
Input impedance Approx. 15k (60Hz), approx. 18k (50Hz)
Input response time OFFON 20ms or less (100VAC 60Hz)
ONOFF
Withstand voltage 1400VACrms for 1 minute between all AC external terminals and the ground
510VACrms for 1 minute between all DC external terminals and the ground
Insulation resistance 10M or higher between all AC external terminals and the ground, all DC external terminals and the
ground (500VDC insulation resistance tester)
Noise immunity Noise voltage: 1500Vp-p (AC type), 500Vp-p (DC type), noise width 1s, noise frequency 25 to 60Hz
(noise simulator condition)
Protection degree IP1X
Wiring method for common 16 points/common (2-wire, terminal block type)
External interface Communication part RJ45 connector
Module power supply part Terminal block for module power supply and FG (Two-piece spring clamp terminal block)
I/O part 34-point two-piece spring clamp terminal block
Applicable DIN rail TH35-7.5Fe, TH35-7.5Al (compliant with IEC 60715/JIS C 2812)
Applicable wire size For power supply Stranded wire: 0.3 to 1.5 (22 to 16 AWG), terminal slot size: 2.8mm 2.0mm
*2
For I/O Stranded wire: 0.3 to 1.5 (22 to 16 AWG), terminal slot size: 2.4mm 1.5mm
*2
Applicable solderless
terminal
Terminal block for module
power supply and FG
*1
Page 81 Applicable solderless terminal
Terminal block for input
*1
Page 85 Applicable solderless terminal
Number of occupied stations One station
Reference response time 1ms
Communication cable An Ethernet cable that meets the 100BASE-TX standard
For details, refer to the following.
CC-Link IE Field Network Basic Reference Manual
Module power supply Voltage 24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
Current 64mA or less (24VDC, all points ON)
Weight 0.26kg
To Next Page
Loading...
