Mitsubishi Electric SD Series - EMERGENCY-STOP Connection

Connection EMERGENCY-STOP connection
SD-/SQ series 4 - 7
4.3 EMERGENCY-STOP connection
Connection for EMERGENCY-STOP pushbutton
● on control unit CR2D and on drive unit DU2 using the plug on the rear of the unit,
● on control unit CR3D and on drive unit DU3 using the plug on the safety module.
The EMERGENCY-STOP inputs are normally blank (see Fig. 4-8). The EMERGENCY-STOP pushbutton,
the door closing contact and an activation (enabling) unit must be connected by the user.
R001462E
Fig. 4-7: Connection for EMERGENCY-STOP circuit
安全ユニット(R700SFT)
MITS UB IS HI
CR3D-TR52
Control unit CR2D or
drive unit DU2
Control unit CR3D or
drive unit DU3
EMGIN
EMGIN
Ferrite core
 30 cm
Ferrite core
EMGOUT
Cable
EMGOUT
 30 cm
Safety module