Select a menu item Operation of Teaching Box R32TB
6 - 6
6.3 Select a menu item
There are two ways to call up a menu:
● Select a menu by entering a number
● Select the menu with the cursor an press the [EXE] key
Running
Both possibilities are displayed in the following example by selecting menu item "1. FILE/EDIT" .
Set the [MODE] switch of the control unit to "MANUAL". Activate the Teaching Box by setting the
[ENABLE/DISABLE] switch of the Teaching Box to "ENABLE".
The start screen appears after switching on. After the start screen appears, press [EXE] key to call
up the main menu.
R001492E
R001493E
MODE
MANUAL AUTOMATIC
Top: disabled
Bottom: enabled (lights up)
Control unit or
drive unit
Teaching Box
Rear of the
Teaching Box
MELFA CRnD-7xx Ver. P2T
RV-6SDL
COPYRIGHT (C) 2008 MITSUBISHI ELEC
TRIC CORPORATION ALL RIGHTS RESE
RVED
<MENU>
1. FILE/EDIT 2. RUN
3. PARAM. 4. ORIGIN/BRK
5. SET/INIT.
CLOSE
123
To Next Page
Loading...
