Mitsubishi Electric SD Series - Handling the Control Unit

Handling the control unit Installation
3 - 14
3.4 Handling the control unit
This section describes the handling and set up of the control unit.
3.4.1 Transport control unit CR2D and drive unit DU2
E
ATTENTION:
Two persons are always required to carry the control unit or the drive unit. To lift, take hold of
the front side and the rear side. Never carry the control unit or the drive unit at their switches or
plug connections.
R001450E
Fig. 3-9: Transport control units CR2D and drive units DU2
!
!