Mitsubishi FREQROL-SF - Page 88

(b) Where the equipment is linked with the
-1
NC through the bus:
External
signal
----_--_
To last axis
CNlB of MR-S
Option card
servo ampli-
fier
Terminatio
resistor
Controller
Option card
SF-TI.
CN I A Bus line
r
_-_-
Orientation position .
command (data)
l-71
CONAA
L
-
E-
1
CONB
1
N/C
Spi
ndle
n ’
CON2
I
(Note) When the direction of the motor rotation differs from
that of the encoder rotation,
it is necessary to change
the bit 8 and bit E of the parameter ORS2 (amplifier
parameter #30; NC parameter 116 (PR)).
- 83 -