Mitsubishi MELSEC-F FX1N-40MT-001 User Manual

FX1N Series Programmable Controllers Installation Notes 3.
3-7
Caution
• Units should not be installed in areas subject to the following conditions: excessive or
conductive dust, corrosive or flammable gas, moisture or rain, excessive heat, regular
impact shocks or excessive vibration.
• Take special care not to allow debris to fall inside the unit during installation e.g. cut
wires, shavings etc. Once installation is complete remove the protective paper band, to
prevent overheating.
3.5 DIN Rail Mounting
Units can be snap mounted to 35mm DIN rail (DIN EN 50022). To release, pull the spring
loaded clips away from the rail and slide the unit up and off.

Mitsubishi MELSEC-F FX1N-40MT-001 Specifications

General

Brand	Mitsubishi
Model	MELSEC-F FX1N-40MT-001
Category	Controller
Language	English