EasyManua.ls Logo

Mitsubishi MELSEC-F FX1N-40MT-001 - Wiring Techniques and Cautions

Mitsubishi MELSEC-F FX1N-40MT-001
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FX1N Series Programmable Controllers Installation Notes 3.
3-11
3.8 Wiring Techniques
ThewiringofFX1N products has been designed to be safe and easy. If during the installation of
these products or associated products concern is felt, please contact a professional electrician
who is trained to the local and national standards applicable to the installation site.
Wiring cautions
Do not run input signals in the same multicore cable as output signals or allow them to
share the same wire.
Do not lay I/O signal cables next to power cables or allow them to share the same
trunking duct. Low voltage cables should be reliably separated or insulated with regard
to high voltage cabling.
Where I/O signal lines are used over an extended distance consideration for voltage
drop and noise interference should be made.
Always ensure that mounted units and blocks are kept as far as possible from
high-voltage cables, high-voltage equipment and power equipment.

Related product manuals