Mitsubishi MELSEC User Manual

12 - 26
12.3 Error Code List
12.3.3 Error code list (1000 to 1999)
12
TROUBLESHOOTING
1411
CONTROL-
BUS ERROR
Module No. – Off Flash Stop
At power ON/
At reset
1413
CONTROL-
BUS ERROR
– – Off Flash Stop Always
1414
CONTROL-
BUS ERROR
––OffFlashStop
When an END
instruction
executed.
1415
CONTROL-
BUS ERROR
Base No. – Off Flash Stop
When an END
instruction
executed.
1500 AC/DC DOWN – – On Off Continue Always
1600
BATTERY
ERROR
*1
Drive Name – On Off Continue Always
1610
EXCEED MAX
FLASH ROM
REWRIT.
ERR.
– – On On Continue
When an END
instruction
executed.
Error
Code
(SD0)
Error
Message
Common
Information
(SD5 to 15)
Individual
Information
(SD16 to 26)
LED Status CPU
Operation
Status
Diagnostic
Timing
RUN ERROR
*1 BAT.ALM LED is displayed at BATTERY ERROR.

Mitsubishi MELSEC Specifications

General

Category	Programmable Logic Controller (PLC)
Manufacturer	Mitsubishi Electric
Series	MELSEC
Programming Languages	Ladder Diagram (LD), Function Block Diagram (FBD), Structured Text (ST), Instruction List (IL), Sequential Function Chart (SFC)
Communication Protocols	Ethernet, CC-Link, RS-232, RS-485, USB, Profibus, Modbus
Model Series	FX, Q, L, iQ-R, iQ-F
Input Voltage	100-240V AC, 24V DC (varies by model)
Memory Capacity	Varies widely depending on the CPU module and series. Ranges from kilobytes to megabytes.
I/O Points	16 to 8192 points (varies by model)
Communication Ports	Ethernet, RS-232, RS-485, USB (varies by model)
Programming Software	GX Works2, GX Works3, GX Developer
Operating Temperature	0°C to 55°C
Storage Temperature	-25°C to 75°C
Humidity	5% to 95% (non-condensing)
Vibration Resistance	10 to 57Hz, 0.075mm amplitude; 57 to 150Hz, 9.8m/s² acceleration
Shock Resistance	147m/s², 3 times in each direction (X, Y, Z)
Protection Class	IP20 (varies by model)
CPU Processing Speed	0.02μs to 0.1μs per instruction (varies by model)