Mitsubishi MELSEC User Manual

12 - 46
12.3 Error Code List
12.3.7 Error code list (5000 to 5999)
12
TROUBLESHOOTING
12.3.7 Error code list (5000 to 5999)
The following shows the error messages from the error code 5000 to 5999, the
contents and causes of the errors, and the corrective actions for the errors.
Table12.6 Error code
Error
Code
(SD0)
Error
Message
Common
Information
(SD5 to 15)
Individual
Information
(SD16 to 26)
LED Status CPU
Operation
Status
Diagnostic
Timing
RUN ERROR
5001 WDT ERROR
Time (value
set)
Time (value
actually
measured)
Off Flash Stop Always
5010
PROGRAM
SCAN TIME
OVER
Time (value
set)
Time (value
actually
measured)
On On Continue Always

Mitsubishi MELSEC Specifications

General

Category	Programmable Logic Controller (PLC)
Manufacturer	Mitsubishi Electric
Series	MELSEC
Programming Languages	Ladder Diagram (LD), Function Block Diagram (FBD), Structured Text (ST), Instruction List (IL), Sequential Function Chart (SFC)
Communication Protocols	Ethernet, CC-Link, RS-232, RS-485, USB, Profibus, Modbus
Model Series	FX, Q, L, iQ-R, iQ-F
Input Voltage	100-240V AC, 24V DC (varies by model)
Memory Capacity	Varies widely depending on the CPU module and series. Ranges from kilobytes to megabytes.
I/O Points	16 to 8192 points (varies by model)
Communication Ports	Ethernet, RS-232, RS-485, USB (varies by model)
Programming Software	GX Works2, GX Works3, GX Developer
Operating Temperature	0°C to 55°C
Storage Temperature	-25°C to 75°C
Humidity	5% to 95% (non-condensing)
Vibration Resistance	10 to 57Hz, 0.075mm amplitude; 57 to 150Hz, 9.8m/s² acceleration
Shock Resistance	147m/s², 3 times in each direction (X, Y, Z)
Protection Class	IP20 (varies by model)
CPU Processing Speed	0.02μs to 0.1μs per instruction (varies by model)