Mitsubishi MELSEC User Manual

12
TROUBLESHOOTING
12.3 Error Code List
12.3.8 Error code list (8000 to 9000)
12 - 53
9
EMC AND LOW VOLTAGE DIRECTIVES
10
LOADING AND INSTALLATION
11
MAINTENANCE AND INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
8310
The installed product is different from
the specified one by network parameter.
Check that [Model name], [Module
technical version] or [Production
information] of the CC-Link Safety
remote station set in the network
parameter matches the product
information of the relevant CC-Link
Safety remote station.(Refer to the
manual of the CC-Link Safety remote
module for the confirmation.)
QS
8320
The response data cannot be received
during the initial processing of CC-Link
Safety remote station.
• Check that the following operations
are not executed.
(1)Switching the operation mode
(2)Writing the program memory to
ROM
(3)Registration/change of the CPU
access password
(4)Initialization of PLC memory
(If executed, this error may occur due
to the increase of the interval between
data communications of CC-Link
Safety.)
• When instantaneous power failure
occurs to the supply power, change to
the asynchronous mode or slow down
the speed.
• Execute the link test to check the
soundness of transmission path.
• Check the setting of transmission
speed.
• Check if the setting value of the
Safety refresh monitoring time is
appropriate.
• Check if the setting value of the
Safety data monitoring timer is
appropriate.
• Check if the setting value of the
Safety data monitoring timer is
appropriate.
QS
8321
The response data cannot be received
during the normal communication with
CC-Link Safety remote station.
QS
8322
The response data cannot be received
during processing error information
from CC-Link Safety remote station.
QS
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU

Mitsubishi MELSEC Specifications

General

Category	Programmable Logic Controller (PLC)
Manufacturer	Mitsubishi Electric
Series	MELSEC
Programming Languages	Ladder Diagram (LD), Function Block Diagram (FBD), Structured Text (ST), Instruction List (IL), Sequential Function Chart (SFC)
Communication Protocols	Ethernet, CC-Link, RS-232, RS-485, USB, Profibus, Modbus
Model Series	FX, Q, L, iQ-R, iQ-F
Input Voltage	100-240V AC, 24V DC (varies by model)
Memory Capacity	Varies widely depending on the CPU module and series. Ranges from kilobytes to megabytes.
I/O Points	16 to 8192 points (varies by model)
Communication Ports	Ethernet, RS-232, RS-485, USB (varies by model)
Programming Software	GX Works2, GX Works3, GX Developer
Operating Temperature	0°C to 55°C
Storage Temperature	-25°C to 75°C
Humidity	5% to 95% (non-condensing)
Vibration Resistance	10 to 57Hz, 0.075mm amplitude; 57 to 150Hz, 9.8m/s² acceleration
Shock Resistance	147m/s², 3 times in each direction (X, Y, Z)
Protection Class	IP20 (varies by model)
CPU Processing Speed	0.02μs to 0.1μs per instruction (varies by model)