12
TROUBLESHOOTING
12.3 Error Code List
12.3.8 Error code list (8000 to 9000)
12 - 55
9
EMC AND LOW
VOLTAGE
DIRECTIVES
10
LOADING AND
INSTALLATION
11
MAINTENANCE AND
INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
8330
The received command differs from the
expected value.
• Check the cable status visually or by
a line test.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
QS
8331
Lapse in separated receiving data has
occurred.
QS
8332
The link ID in receiving data is different
from the expected value.
• Check if the link ID setting of the
relevant remote station and the link
ID that has been set in the network
parameter are identical.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
QS
8333
The running No. in receiving data is
different from the expected value.
• Check if the setting value of the
Safety refresh monitoring time is
appropriate.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
QS
8334
The CC-Link Safety master station
cannot recognize the separated data.
• Check the cable status visually or by
a line test.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
QS
9000
Annunciator (F) was set ON
(**** in the error message indicates the
detected annunciator number.)
Read the individual information of the
error using the GX Developer, and
check the program corresponding to the
numerical value (annunciator number).
QS
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
To Next Page
Loading...
