2. SIGNALS AND WIRING
2 - 24
(2) OVR (Analog override selection)
Enable or disable VC (Analog override).
Analog
override
OVR (Analog override selection)
VC (Analog override)
-10 V to +10 V
Servo
motor
Servo amplifie
Position
control
Speed
control
Select a changed value by using OVR (Analog override selection).
(Note) External input signal Speed change value
0 No change
1 Setting of VC (Analog override) is enabled.
Note. 0: Off
1: On
(3) Analog override offset ([Pr. PC37])
You can set an offset voltage to the input voltage of VC (Analog override) with [Pr. PC37]. The setting
value ranges from -9999 to +9999 [mV].
To Next Page
Loading...
