3. DISPLAY AND OPERATION SECTIONS
3 - 3
3.1.2 Status display mode
The servo status during operation is shown on the 5-digit, 7-segment LED display. Press the "UP" or
"DOWN" button to change the display data as desired. When a servo status is selected, the corresponding
symbol is displayed. Press the "SET" button to display its data. However, only when the power is turned on,
the data will be displayed after the status symbol selected with [Pr. PC36] is displayed for 2 s.
(1) Display transition
After selecting the status display mode with the "MODE" button, pressing the "UP" or "DOWN" button
changes the display as follows:
To Next Page
Loading...
