Mitsubishi MR-JE-40A - Point Table Setting

3. DISPLAY AND OPERATION SECTIONS
3 - 13
3.1.5 Point table setting
You can set the target position, servo motor speed, acceleration time constant, deceleration time constant,
dwell, auxiliary function and M code.
(1) Display transition
Target position
Servo motor speed
Deceleration time
constant
Dwell
Auxiliary function
M code
Acceleration time
constant
UP
DOWN
Point table No. 1
Point table transition
Point table No. 2
Point table No. 29
Point table No. 30
Point table No. 31
Point table No. 3
UP
DOWN
SET
MODE
Setting item transition