Mobileye Proprietary and Confidential
support@mobileye.com
There should be no occlusions such as stickers or darkened
windshield areas in front of the Main Unit.
In tall commercial vehicles that do not have an engine hood
occluding the field of view of the camera, the v Main Unit can
be placed on the lower part of the windshield, while
considering all of the above-mentioned requirements. In this
case, you can modify the Main Unit cable to the "DOWN"
positionafter the Main Unit installation,
the Main Unit cable exits the Main Unit downwards, instead of
upwards (which is the case in the default position.
3.2.4.2 Attaching the Camera to the Windshield
1. Before starting the Main Unit installation, make sure that the car is not
loaded with unusual heavy cargo that can tilt the orientation of the car body.
2. Make sure the vehicle is standing on a flat surface with no side or forward
slope.
3. Clean the intended installation location on the windshield using the 3M VHB
Surface Cleaner to remove oily or other remains.
4. Wipe the installation area on the windshield by thoroughly using a dry wipe
(important since the 3M VHB Surface Cleaner that removes oily substances
may leave marks on the windshield that will obstruct the field of
view)
To Next Page
Loading...
