5. Using the TORX wrench TX10 M.9 and the two pre-mounted screws (highlighted red in the figure), fixate
the connector box on the mounting plate:
NOTE! These are self-tapping screws. Make sure to properly tighten but do not over tighten them.
Fig. 66: Mount the Connector Box RJ45 (top view) using the two screws (highlighted red in the figure) on the mounting
plate
CAUTION! Make sure the connector box is properly fastened on the mounting plate as shown above. Failing
to do so could damage the main board of the camera!
Continue with Finishing the Installation of the Camera, p. 82.
Terminal Connectors
All connections to the camera (network, power supply, inputs/outputs) can be made directly on the con-
nector box which part of the camera. A PoE switch provides the camera's power supply (see Connecting the
Camera to the Network, p. 70).
Terminal connectors Connector Box RJ45 Terminal connectors Connector Box LSA
Mounting
Connecting the camera
80 / 110
To Next Page
Loading...
