Mobotix M73 - Page 90

Fig. 74: View of the MOBOTIX M73 from below with LED ① and screw with sealing ② that hides the key inside the camera
body
NOTE! Pressing the key of the camera will let the camera announce the current IP address of the camera on
the speaker (if a speaker is attached to the camera).
Step by Step
1. Prepare the camera:
n
Disconnect the camera's power supply.
n
Remove the Allen screw ② using the Allen wrench 2.5mm M73: Scope of Delivery, p. 14. Take care not
to loose the plastic washer.
n
Take a suitable tool for operating the boot menu (e.g. the enclosed screwdriver M73: Scope of Delivery,
p. 14 or the Allen wrench 2.5mm M73: Scope of Delivery, p. 14. ) but do not use a paper clip or poin-
ted objects!)
n
Reconnect the power supply of the camera.
2.
Activate the boot menu: The red LED ① lights up 5 to 10seconds after establishing the power supply
and will stay on for 10seconds. Press the key by inserting the tool into the hole ② . The camera enters
the boot menu, ready for selecting one of the boot options. The LED will flash once. The flash signal will
be repeated every second.
NOTE! The number of flashes corresponds to the current boot option.
3. Switch the boot option: Briefly press the key (<1sec). After the last boot option, the camera returns to
the first boot option (LED flashes once).
Operating the Camera
Boot Options of the Camera
90 / 110