Operating the Camera
Boot Options of the Camera
LED flashes Boot Option Meaning Audio Confirmation*
1x •/• This option is not sup-
ported on this camera
model.
•/•
2x Factory Defaults Starts the camera with
factory defaults (factory
default IP address, users
and passwords will not
be reset).
Boing
3x Automatic IP Address Starts the camera as
DHCP client and tries to
obtain an IP address from
a DHCP server. If a DHCP
server cannot be found or
no IP address can be
obtained, the camera
starts with its factory
default address.
Boing-Boing
4x Recovery System Starts the camera with
the recovery system, e.g.,
in order to recover from a
failed update of the cam-
era software.
Alarm Sound
*Only on cameras with audio option and installed speaker.
4. Select a boot option: Press the key longer (>2sec). The camera confirms the selection by flashing the
LED rapidly for 3seconds. After 20sec, the camera will play a sound according to the table above.
5. Insert the Allen screws and the plastic washer using the Allen wrench 2.5mm M.7 and take care not to
over-tighten the screw.
NOTE! If you do not select a boot option, the camera will resume its normal boot process after a certain
time.
91 / 110
To Next Page
Loading...
