61
Preparing the Installation
Non-Square Rooms
When viewing a 360° (full) image in the browser, you will notice that the top and bottom of
the image is not fully visible, i.e. some image information has been clipped. This is not a fault
of the camera, but intended behavior that aims at achieving the best possible utilization of
the image sensor by the camera soware. Bearing this in mind, it is advisable to install the
Q26 in rectangular room ceilings so that the arrow marked OBEN / TOP points towards one
of the longer walls of the room as shown in the gure.
Original full image from the
Q26 (ceiling installation
in a rectangular room)
To Next Page
Loading...
