95
Installing the Corner and Pole Mount
Required Parts
Please check that all components supplied with the Corner and Pole Mount Set are present
in the original packaging rst.
The following additional tools are required for installation as a pole mount:
• Screwdriver
• Materials and tools needed to connect the pre-installed MOBOTIX network cable in
the camera with the on-site network cable.
The following additional tools are required for installation of the corner mount:
• Power drill for screw anchor holes
• Screwdriver
• Scissors to cut out the template
• Pen to mark the hole positions
• Materials and tools needed to connect the pre-installed MOBOTIX network cable in
the camera with the on-site network cable.
To Next Page
Loading...
