Mocom millenium B2 - Time and Password Configuration

6. CONFIGURATION
24
Setting the time
(TIME SETTING on the
BASIC menu)
When TIME SETTING is selected with the ↵ key, you will see:
hh:mm:ss
+/- to set
↵ to enter
Ç to exit
Proceed as follows:
– The hours flash: set the current hour with the + and - keys. Confirm with ↵.
– The minutes flash: set the current value with the + and - keys. Confirm with ↵.
The time is stored. Once the last confirmation is given, you return to the second-level menu.
Setting the password
(PASSWORD on the
BASIC menu)
When PASSWORD is selected with the ↵ key, you will see this menu:
→
DISABLED +
ANY POWER ON ↑
ANY CYCLE START ↓
EXIT -
Select DISABLED to use the device freely, without any limitation on operator access.
Select ANY POWER-ON to protect the machine with a password at the time it is turned-on
(power-on from the main switch).
This makes sure that the machine can only be powered-on by authorized personnel, but
afterwards it can be used by others without limitation.
Select ANY CYCLE START to protect the autoclave with a password to be entered both at
power-on and at the start of every sterilization program.
Only authorized personnel will be able to use it.
NOTE
ENTERING A PASSWORD PROVIDES MORE CONTROLLED USE OF THE PRODUCT BUT, AT
THE SAME TIME, INEVITABLY MAKES IT MORE CUMBERSOME. SO AS NOT TO OVERLY
COMPLICATE USING THE DEVICE
, WE RECOMMEND ONLY ACTIVATING THIS OPTION WHEN
IT IS REALLY NEEDED
.
When the ANY POWER-ON or ANY CYCLE START options are selected, the following
screen is displayed:
INSERT PASSWORD
↵ to enter
Ç to exit
Enter the password with the + and – keys (fixed length, 8 characters).
Confirm with the ↵ key. Then, the following message will appear:
CONFIRM PASSWORD
↵ to enter
Ç to exit
Enter the password again using the + and – keys.