The ENTER REF function lets you enter the product code
specific to each individual model.
This code is stored at the factory and needs only to be re-
entered after the PCB has been replaced. The procedure is
outlined below.
From SERVICE MENU:
- Select ENTER REF
- insert a USB memory with the original FW version or a later
version
- ensure that the USB memory is detected and this is
confirmed by two beeps
- confirm with ENTER to display the product codes belonging
to the same series
- the proper code is reported on the ID plate on the rear panel
- select the correct code and confirm it
Function SN INPUT lets you store the unique serial number
of each individual autoclave.
The serial number is stored at the factory using the three
counters displayed when confirming with ENTER.
The two letters, unique to each model, are automatically
assigned when product code is entered (see REF INPUT).
To Next Page
Loading...
