14.8.5 Set Gate Close Points
Gate close points can be chosen from these three parameters:
• a xed point in time
• a period of time after opening
• a nominated screw position
One simple option is to select [Time (inc)], which allows all gates to be set in
a single step. All gates stay open for the same amount of time.
1. Choose all of the gates:
2. Touch anywhere in the Close Trigger column:
14-21
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
SEQUENCE VALVE GATE OPTION
M2+ Controller User Manual
To Next Page
