5.4 Set Chillers, Cavities and Water Flow Zones
The user can set or change a single zone’s temperature or the user can use
[Range] to change multiple zones simultaneously. See "4.13 Choose Zones"
on page 4-18 for more information about the Range function.
1. Choose the required zone or zones:
2. Choose [Set]:
3. Enter password, if required.
A keypad opens:
4. Choose [Manual] for the mode.
5-7
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
SETUP
M2+ Controller User Manual
To Next Page
