Mold-Masters TempMaster M2 Plus Series - Page 80

5. Enter the required values using the keypad or choose:
• [Add] to increase the current temperature by a set amount
• [Subtract] to decrease the current temperature by a set amount
NOTE
The values set must fall within the limits set on the Settings screen.
See "5.5.1 Congure Tool Parameters Zone by Zone" on page 5-10 for
information on how to change these limits.
6. Choose [Enter] to accept the changes and return to the Display screen,
or choose [Esc] to clear the input.
The user can return to the Display screen at any time by choosing [Esc]
twice.
For more information on water ow control and monitoring, see "Section 11 -
Water Manifolds" on page 11-1.
Set Chillers, Cavities and Water Flow Zones - continued
5-8
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
SETUP
M2+ Controller User Manual