Mold-Masters TempMaster M2 Plus Series - Page 9

13.7.2 Dynamic Remote Tool Load ...................................................................13-9
Section 14 - Sequence Valve Gate Option................... 14-1
14.1 Introduction .....................................................................................................14-1
14.2 Further Inputs .................................................................................................14-1
14.3 Setup ..............................................................................................................14-2
14.3.1 Congure SVG Card Type .....................................................................14-2
14.4 Congure SVG Mode .....................................................................................14-3
14.5 Standard Mode ...............................................................................................14-3
14.5.1 Global Settings ......................................................................................14-3
14.5.2 View or Print the SVG Settings ..............................................................14-6
14.6 Congure SVG Input - Digital .........................................................................14-8
14.7 Congure SVG Input - Analogue ..................................................................14-10
14.8 Gate Timing Options .....................................................................................14-14
14.8.1 Use Time Values Alone ........................................................................14-14
14.8.2 Use Screw Position Alone ....................................................................14-14
14.8.3 Use a Combination of Time and Position.............................................14-15
14.8.4 Set Gate Open Points ..........................................................................14-16
14.8.5 Set Gate Close Points .........................................................................14-21
14.8.6 View or Test the SVG Sequence .........................................................14-25
14.8.7 Troubleshooting ...................................................................................14-26
14.9 Relay Output Mode ....................................................................................... 14-30
14.10 External Wiring Connections ......................................................................14-34
14.10.1 Outputs ..............................................................................................14-34
14.10.2 Output Rating .....................................................................................14-34
14.10.3 Inputs (North American Version) ........................................................14-35
14.10.4 Inputs - European Version .................................................................14-36
14.11 Handshake Inputs (Optional) ......................................................................14-36
Section 15 - Fitlet2* Option ........................................... 15-1
15.11.1 Fitlet2 - Introduction .............................................................................15-1
15.11.2 Fitlet2 - External Connections ..............................................................15-1
15.11.3 Fitlet2 - Screen Layout .........................................................................15-2
15.11.4 Fitlet2 - Upgrade Software ...................................................................15-2
15.11.5 Fitlet2 - Connection ..............................................................................15-2
Index ......................................................................................I
Section 16 - Index .................................................................I
vii
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
M2+ Controller User Manual